Fan and light installation

1. This part is fairly easy. Just use the screws to attach the fan to the window. Make sure that you look on the fan for the flow arrows so you have proper air flow.

2. Make sure the grill is attached to the outside of the plexi-glass window

3. Next use the supplied velcro strips (That are provided with the the cold-cathode light). Make sure that you place the light where it will give you the most light output. Either on the floor of the case or the door (as I did as shown) is a good place.

4. For added effect, I applied a self-adhesive window sticker. First, make sure that you clean the BACK of the window with a good window cleaner. This allows for a better stick.

5. The trick to these are to pull the backing off first... Make sure that you place the sticker level and then pull back the top level adhesive SLOOOOWWWWLLY. If you do not, then the sticker could tear. The adhesive on these stickers is STRONG!.

6. Next use a credit card or driver's license to smooth out the bubbles from the sticker.

7. After that, just hook up the power and put the door back on the case.

Here are some pictures of the finished product. Next time, I'll post an article on adding a blow hole to your case.
Stay tuned!!!!